Slip Padding Order Form
At the start of the Basin Renovation Project, a committee of members was formed to develop standards for the new docks. This was to insure that our docks continue to have a uniform and clean look for years to come.
The policies set fourth where as follows;
- Members may not make any modification to the docks.
- No carpet, hand rails or rub rail can be installed.
- Dock boxes are not mandatory, but if you want a dock box it must be purchased from the Club at our cost which will include installation.
- As time has passed it’s been brought to the Dock Committees attention that some of our slip holders would like some padding on their slips. A previous Dock Committee approved a “cross link foam” product that has been tested and held up extremely well over the last five years. This two inch thick product can be installed on the vertical uprights, horizontal boards or both if you so choose. The Committee also approved a similar type padding product that can be installed on the middle piling.
The Club will install these products in your slip at the location that you specify. For example, if you have a power boat, you may only want your uprights padded while a sailor may want padding on their horizontal boards. Each pad is 48 inches long, 6 inches wide and 2 inches thick and you must specify how many pads you would like, as well as their location. The piling pad is 33 inches long, 24 inches wide and a half inch thick. Each pad costs $30.00 installed, while the piling pad cost $20.00.
If you would like to have padding installed on your slip please fill out the enclosed order form and return it to the Club as soon as possible. If you would like to see an example of the padding feel free to take a look at slip L-24 or N-09, which has had the padding installed for a few years.